simon.r wrote:Oooo how much are these ? Easy to fit ?
How do you go abouts closing the bonnet now - you dont have to push it down on the bonnet itself?
Remove the top bonnet hinge securing bolt then place the upper bracket / ball joint, then secure with same bolt, dont overtighten. The lower section ,remove the middle wing bolt, then replace with the lower damper ball joint. Connect damper to upper and lower joint, insert the wire clips to stop the dampers popping off the upper and lower ball joints, job done
Open the bonnet, lift, there maybe slight resistance to half way open, the dampers will then take over. Closing the bonnet, there will be slight resistance as you lower to half way, then close as normal. Please note, resistance is only slight. The bonnets weight and gravity does the rest. No pushing or pulling required
Hope this helps....