Page 1 of 1
centre section exhaust de-cat
Posted:
Mon Feb 05, 2007 6:17 amby steff109
is it worth getting one or have they already been removed as not had chance to have a look yet
Posted:
Mon Feb 05, 2007 9:54 amby WR 1mposter
No center cat
The up-pipe is catless aswell
The only cat is the Prodrive downpipe
which some say is just as good as a de-cat
Posted:
Mon Feb 05, 2007 7:20 pmby SPIKE LIKE MIKE
WR 1mpostor (aka number 1 moderator) wrote:No center cat
The up-pipe is catless aswell
The only cat is the Prodrive downpipe
which some say is just as good as a de-cat
Agreed but de-catting the down pipe d0es increase the "burble" quite substantially
Posted:
Mon Feb 05, 2007 9:56 pmby Anders_WR1
...and also adds boost creep, unless you port the turbo wastegate.
Anders
Posted:
Mon Feb 05, 2007 10:21 pmby SPIKE LIKE MIKE
Anders_WR1 wrote:...and also adds boost creep, unless you port the turbo wastegate.
Anders
Probably...
If your getting a de-cat go for a remap as well @
Posted:
Tue Feb 06, 2007 10:22 pmby steff109
is there a high flow centre section available ?
Posted:
Tue Feb 06, 2007 10:38 pmby marky mark
There is not a cat in the centre as o.e...you can't get much higher flow than that.
You can get replacement stainless centres though.
Posted:
Wed Feb 07, 2007 6:10 amby steff109
i was just going by the fact it has a very small silencer on it that was all suppose straight through centre section would make it just a tad louder then
Posted:
Wed Feb 07, 2007 2:05 pmby Anders_WR1
steff109 wrote:i was just going by the fact it has a very small silencer on it that was all suppose straight through centre section would make it just a tad louder then
I fitted a non-resonated centre section and it got a bit louder. It lets a few more pops and bangs through, but not as much as a full decat would.
The cabin noise is fine too
Anders
Posted:
Wed Feb 07, 2007 6:08 pmby steff109
can i ask where you got it from
Posted:
Wed Feb 07, 2007 6:11 pmby SPIKE LIKE MIKE
HAYWARD AND SCOTT - Will supply Stainless zorsts with lifetime gaurantee at a fraction of teh cost of dealers - they manufacture for quite a few.
they are based in Essex and if you call them they will usually change components feww of chareg and also arrange for the cel fix to be done for around
Posted:
Thu Feb 08, 2007 12:55 amby WR 1mposter
[quote="Spike "THE LEGEND" Mike XXX"]HAYWARD AND SCOTT - Will supply Stainless zorsts with lifetime gaurantee at a fraction of teh cost of dealers - they manufacture for quite a few.
they are based in Essex and if you call them they will usually change components feww of chareg and also arrange for the cel fix to be done for around
Posted:
Thu Feb 08, 2007 9:02 amby SPIKE LIKE MIKE
[quote="WR 1mpostor (aka number 1 moderator)"][quote="Spike "THE LEGEND" Mike XXX"]HAYWARD AND SCOTT - Will supply Stainless zorsts with lifetime gaurantee at a fraction of teh cost of dealers - they manufacture for quite a few.
they are based in Essex and if you call them they will usually change components feww of chareg and also arrange for the cel fix to be done for around
Posted:
Thu Feb 08, 2007 12:06 pmby Anders_WR1
steff109 wrote:can i ask where you got it from
I bought mine second hand on ScoobyNet for