WR1 Owners Club

hi what is standard ride height on the wr1?
i have bc coilovers fitted and looks way too much arch showing.
they measure approx 110mm from top of rim to arch .
what is it on a standard anyone?

Ride height is measured from the centre of the wheel to the lower lip of the wheel arch. Did you not take any measurements from the standard set up before fitting the coils?

That looks a good 25mm over standard to me..... Are you going cross country

I have standard fitted.

Back 14 inches ( 355 mm )
Front 14 inches ( 355 mm )

Hope this helps

coilovers were on car when i bought it . so no idea what it was before!
will measure to centre now then.
just found it easier to measure to 2 definate edges for picture .
cheers.

diameter of alloy is 498mm.
divided by 2 equals 249mm plus 115mm 365mm.
so only 10 mm high?
looks more.