Login    Register

Fitting New Driving Lights -

Ask your technical questions here.

Moderators: WR 1mposter, The Swede, Megaman, danr55, WR1 Bro

  • Author
    Message

Fitting New Driving Lights -

Postby simon.r » Sun Dec 09, 2012 12:04 pm

Anyone got any photos of how to remove the old ones to install new?

Cheers
simon.r
 
Posts: 179
Joined: Sat Mar 10, 2012 1:15 pm

Re: Fitting New Driving Lights -

Postby Carl Curtis » Sun Dec 09, 2012 7:14 pm

Its a doddle Simon. Prize off the driving light surrounds with a suitable screwdriver. Try to protect the paintwork by wrapping some tape around it.
Once you have done this you will see that 3no stainless 6mm bolts hold them onto the bumper brackets. Give them a squirt of WD40 or something similar.These bolts have springs behind them to enable you to set the angle of the lights to your desired position. Probably best to measure how far each bolt is currently positioned so you can put them back again in the same positions.
There is a plug and socket behind the lights when you pull them out. Disconnect this obviously and fitting is the reverse of removal.

Good luck and hope it works smoothly.

Carl.
Carl Curtis
 
Posts: 145
Joined: Tue Jan 18, 2011 8:51 pm
Location: Coventry

Re: Fitting New Driving Lights -

Postby simon.r » Wed Dec 19, 2012 5:05 pm

Fitted - bit of a chew on - but got it fitted in the end...

looks the bee's now.
simon.r
 
Posts: 179
Joined: Sat Mar 10, 2012 1:15 pm

Return to Tech Help

Who is online

Users browsing this forum: No registered users and 13 guests